The trunk lid is open. You need to unlock the main driver's door, and then open the main driver's door. At the lower left of the door trim panel, you will find a trunk open button, press it with your hand, and the trunk lid of the car will open.
Removal of the trunk lining. After the rear cover is opened, you need to disassemble the cotton lining on the side of the taillight, and you will find that there are several plastic buckles that fix the cotton lining. You only need to use a small screwdriver to pry these buckles open, and then use your hand. Just peel off the cotton lining. Be careful when prying the clips slowly to avoid damaging the plastic clips.
Removal of the fixed rear tail light nut. There are three nuts for fixing the rear taillights of the car. Take out the small wheel, match it with the No. 8 sleeve, and then remove the three nuts fixed on it one by one. The removed nuts should be put away for installation.
Removal of the rear tail light harness. The taillight wiring harness of the car has only one wire plug. The structure is quite simple. You only need to unplug the wire harness plug by hand. The plug can be removed.
Initial disassembly of the rear tail light. You can remove the rear taillights, hold both sides of the rear taillights of the car with both hands, and then gently pull them out, shaking them slightly while pulling, so that the rear taillights of the car are separated from the car body. It is not easy to pay too much attention. The whole process of removing the rear tail light of the car is over.
dkcarlamp.com